Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Running Springs, CA
Most of what we do in Running Springs starts with a repair question, not a routine sweep. The housing stock here runs heavily toward mountain cabins and chalets built between the 1940s and 1970s, and those chimneys have seen decades of snow loads, freeze-thaw cycles, and heavy burn seasons. We see cracked crowns, failing flashing, and liners that predate modern code far more often than we see a chimney that just needs a basic cleaning. Corona Chimney Sweep has served Running Springs since 2018, and we handle the full scope: chimney repair, chimney sweeping, and dryer vent cleaning. Call (855) 382-6159 and we’ll tell you exactly what we find.
Why Running Springs Homes Are Different
Running Springs sits above 6,000 feet in the San Bernardino Mountains. That single fact changes how we approach almost every chimney job here. Homes rely on wood-burning stoves and fireplaces as primary or backup heat for much of the year, which means the burn season stretches from fall through late spring. Creosote builds faster when a stove runs daily for six months. It builds even faster when the operator is burning pine or fir that hasn’t fully seasoned, which happens often in the mountains. We also work on a lot of second homes and vacation cabins that sit empty for months at a time. Those chimneys give us a different set of problems: nests, debris from squirrels and birds, rusted dampers, and creosote that has hardened into a glaze. Snow loads bend and loosen chimney caps. Freeze-thaw cycles crack mortar crowns. Steep-pitched roofs make access tricky, especially in winter. Any sweep or repair crew working Running Springs needs to know these conditions because they change the job.
Styles & brands we work with
Our Main Running Springs Services
Running Springs homeowners call us most often for two things: a chimney sweep ahead of burn season, and dryer vent cleaning when they’re already thinking about fire hazards in the home.
Chimney Sweep in Running Springs
A sweep here is less about tidiness and more about clearing the creosote that builds up after months of daily wood burning. Mountain-grade creosote, especially the glazed kind, is the stuff chimney fires feed on. We remove it with rotary brushes sized to your flue, inspect the entire system as we go, and leave you with a clear picture of what’s safe to burn and what isn’t. In Running Springs, we often find second-home chimneys that haven’t been touched in years. That’s exactly where the danger lives. For the full breakdown of what a sweep includes here, see Chimney Sweep in Running Springs.
Dryer Vent Cleaning in Running Springs
A clogged dryer vent is a fire waiting to happen, and mountain cabins have a specific vulnerability: long vent runs squeezed through tight framing, often routed through roofs or crawl spaces that are hard to reach. Lint builds fast when the outside vent is cold and moisture condenses inside. We treat dryer vent cleaning as its own fire-prevention service, not a quick add-on. Our technicians are trained in combustion venting, so they understand airflow the way a chimney crew should. Details are on Dryer Vent Cleaning in Running Springs.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Running Springs
Chimney repair in Running Springs is rarely a single-issue job. Between the age of the housing stock, the snow and ice, and the way mountain homes switch between wood stoves, inserts, and occasional gas appliances, most repairs end up touching more than one part of the chimney. The most common call we get is for water damage that has gone unnoticed for a season or two. A cracked crown lets moisture into the masonry. A loose flashing lets snowmelt run behind the chimney chase. And a deteriorated liner is the one we lose sleep over, because that’s the part standing between combustion gases and the living space. We repair what we find, and we don’t hand the work off to a third party. That’s the entire point: one crew, one diagnosis, one fix. See Chimney Repair for how we approach liner work, masonry, caps, and dampers.
Chimney Cap Installation
Signs you need it
You see rust flakes on the hearth after a storm, hear birds or squirrels inside the flue, or notice the old cap has been dented and twisted by heavy snow or fallen pine branches.
What it costs in Running Springs
Cap installation typically runs $225 to $450 depending on flue size and access, with stainless and copper options landing between $350 and $750.
How we do it
We measure the flue opening, match a cap from Olympia Chimney or Gelco to the clay tile or metal flue, secure it with mechanical fasteners, and verify the draft is unaffected.
Chimney Cap Replacement
Signs you need it
The existing cap is missing sections, has rusted through, or has been lifted off its seat by wind or sliding snow, leaving the flue open to debris and animals.
What it costs in Running Springs
Replacement plus removal of the old cap typically runs $250 to $475, with exact pricing tied to whether it’s a standard single-flue or a custom multi-flue setup.
How we do it
We pull the damaged cap, inspect the flue crown beneath it for damage, install the new cap from our stocked Olympia Chimney or Gelco inventory, and seal all contact points.
Chimney Liner Installation
Signs you need it
Flue tiles are cracked, mortar joints are missing, or the chimney has no liner at all and you’re being told by an inspector or insurance company that the system doesn’t meet current code.
What it costs in Running Springs
Stainless steel liner installation in Running Springs typically runs $2,800 to $5,900, while aluminized liners for gas-only systems fall between $2,300 and $4,900.
How we do it
We size the liner to the appliance and flue dimensions, run a DuraFlex stainless flexible liner down the full length of the chimney, insulate where code and mountain cold demand it, and connect everything at both the appliance and termination points.
Chimney Flashing Repair
Signs you need it
You see water staining on the ceiling around the chimney chase, peeling paint near the roofline, or damp spots in the attic after a snow or rain event.
What it costs in Running Springs
Flashing repair typically runs $400 to $950 in Running Springs, with steeper roofs and second-story access pushing toward the upper end.
How we do it
We remove the failed flashing, cut and fit new step and counter flashing from Copperfield materials, seal the joints with a mountain-grade polyurethane sealant, and test for water intrusion.
Chimney Crown Repair
Signs you need it
The top mortar slab is cracked, spalling, or has pieces missing, and water is working its way into the masonry below during freeze-thaw cycles.
What it costs in Running Springs
Crown repair runs $650 to $1,300 for a standard chimney, while a full concrete crown rebuild starts around $900 and goes up with access difficulty.
How we do it
We remove deteriorated material, build a proper crown with an overhang and drip edge using a durable polymer-modified mix, and seal the whole top surface against standing moisture.
What Chimney Repair Costs in Running Springs
| Item | Typical range in Running Springs |
|---|---|
| Chimney cap installation | $225 – $450 |
| Chimney cap replacement | $250 – $475 |
| Chimney liner installation | $2,300 – $5,900 |
Do I need a new liner, or can the old one be repaired?
Not every deteriorated liner means a full replacement. If the damage is limited to hairline cracks or failing mortar joints, HeatShield resurfacing can restore the flue interior and buy your chimney years of safe use. We’ll only recommend replacement when the liner is structurally unsound or the appliance has changed. Call us for a camera inspection and we’ll show you exactly what we’re seeing.
Can a chimney cap survive a Running Springs winter?
The right cap can, but the wrong one won’t. Snow sliding off a steep metal roof hits the cap with real force, and cheap sheet-metal caps crumble. We spec caps built for mountain exposure, and the installation matters as much as the cap itself. Most cap jobs here are done in a single trip.
Brands We Service in Running Springs
We install and service materials from six professional-grade lines: DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield. These are the same brands contractor supply houses carry, not big-box substitutes. In Running Springs, we keep common cap sizes, flashing materials, and liner components stocked on the truck so we can move fast on typical repairs. See our brands for details on what we carry and why.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Running Springs, CA
| Service | Typical range in Running Springs |
|---|---|
| Chimney sweep | $180 – $340 |
| Chimney cap installation | $225 – $450 |
| Chimney cap replacement | $250 – $475 |
| Chimney liner installation | $2,300 – $5,900 |
| Chimney flashing repair | $400 – $950 |
| Chimney crown repair | $650 – $1,300 |
| Dryer vent cleaning | $150 – $400 |
Prices in Running Springs shift for two reasons: access and elevation. Steep roofs with snow on them take longer to work on safely, and the more equipment we have to haul up a ladder line, the more labor a job consumes. That said, we give you a flat price before we start any repair, and we don’t pad quotes with mystery line items.
Neighborhoods We Serve in Running Springs
We work the entire Running Springs area, from the older cabin clusters near Highway 18 up through the side streets that climb toward the ridge. Some areas have flat lots and easy roof access; others require roof ladders and a lot of patience. We schedule by area and terrain, not by ZIP, so we can group calls efficiently and get you in without waiting weeks.
- Upper Rowco
- Lower Rowco
- Smiley Park
- Arrowbear Lake area
- Green Valley Lake Road corridor
Service Area – Cities Near Running Springs
We also serve the surrounding mountain and foothill communities. If you’re in Lake Arrowhead, CA, Highland, CA, Mentone, CA, or Crestline, CA, we can schedule a sweep or repair with the same crew and the same equipment. Call the main line and we’ll route you to the right day.
Serving Running Springs, CA — Our Local Coverage Area
We’re based in the Running Springs area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Running Springs
Most sweeps and inspections in Running Springs can be scheduled within a week, sometimes faster if we have another job in the mountain area that day. Repairs take longer to schedule because we’re matching materials and access windows, but we’ll always give you a honest time range when you call.
Liner installations and structural masonry work can require a permit depending on the scope and the county’s current requirements. We handle the permit paperwork as part of the job when it’s needed. For routine sweeps and cap replacements, permits are generally not required in Running Springs.
Yes, and that’s a big part of our Running Springs work. We’re used to meeting at a cabin that hasn’t been opened in months, and we know the problems those places develop: critters, moisture, rust, and creosote that’s been sitting for seasons. We’ll document everything with photos so you can make decisions from wherever you are.
If your chimney hasn’t been looked at in the last year, or you’re opening up the cabin and something doesn’t smell right, call (855) 382-6159 for a free estimate. We’ll come up, look at it, and tell you what needs doing and what can wait. No pressure, just a straight answer.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Running Springs Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
— Imani Dawson"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Veronica Flores"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Jodi Brooks