Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Florence-Graham, CA
Chimney repair is the service we handle most in Florence-Graham, and the reason is straightforward: this is a community of 1920s through 1960s stucco bungalows and small duplexes, most with original masonry fireplaces and clay-tile flues that have never been touched. The mild Southern California climate means fireplaces get lit maybe a dozen times a year, so creosote isn’t the main concern. The real problems are fifty to ninety years of settling cracks, deteriorated mortar joints, and flues blocked by debris from years of sitting idle. We repair what we find, in-house, and we’ve served Florence-Graham since 2018. Call (855) 382-6159 if you know your fireplace hasn’t been looked at in years.
Why Florence-Graham Homes Are Different
Florence-Graham is unincorporated Los Angeles County, densely built with homes packed shoulder-to-shoulder on small lots. That density changes the stakes. A cracked flue in one bungalow on a narrow side-yard setback is a fire risk for the house next door too. Most of the fireplaces here are original brick or block masonry units with clay-tile liners, built when the homes went up between the 1920s and 1960s. Clay tile was the standard then, and it handles heat well for a while. But clay tile cracks under decades of thermal cycling, seismic settling, and simple age. Once a liner cracks, the chimney is no longer safely containing combustion gases and heat. We see this pattern constantly in the 90001 ZIP code: an original fireplace that looks fine from the hearth, but the flue interior tells a different story.
The climate matters here too. Florence-Graham doesn’t get hard freezes or heavy rain like other markets, so homeowners don’t get seasonal reminders to inspect. Fireplaces sit unused for years. That idle time is when birds build nests, leaves and debris accumulate, and small cracks widen without anyone noticing. By the time a homeowner fires up the fireplace for a holiday or a cold snap, the flue may be partially blocked or structurally compromised. Much of our work in Florence-Graham is inspection and education more than heavy soot removal. We spend time showing homeowners the camera footage of what’s actually inside their flue, because most have never seen it.
Styles & brands we work with
Our Main Florence-Graham Services
Florence-Graham homeowners call us most about two services: chimney sweeping for the inspection and cleaning of aging flues, and dryer vent cleaning for the fire hazard that builds up in laundry rooms. Here’s what each involves in this area.
Chimney Sweep in Florence-Graham
A sweep in Florence-Graham is more than removing soot. Because fireplaces here sit idle for long stretches, we’re mostly clearing out debris, bird nests, and creosote that hardened during years of sporadic use. We inspect the flue liner with a camera as part of the job, because the age of these homes means hidden cracks are common. Most Florence-Graham chimneys are original clay tile, and a camera inspection is the only way to see joint deterioration before it becomes a fire risk. Read the full breakdown on our Chimney Sweep in Florence-Graham page.
Dryer Vent Cleaning in Florence-Graham
Lint buildup in dryer vents is a leading cause of residential structure fires, and in Florence-Graham’s tightly packed housing, that risk is amplified. Dryer vents here run through small laundry closets and often have long, angled runs that trap lint fast. We treat dryer vent cleaning as fire prevention, done by the same technicians trained in combustion venting, not a separate crew. A clogged dryer vent is a fire waiting to happen. Full details are on our Dryer Vent Cleaning in Florence-Graham page.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Florence-Graham
Chimney repair in Florence-Graham is usually about old, ignored flues finally showing their age. The typical call starts with a homeowner noticing water stains near the fireplace, a musty smell, or pieces of tile in the firebox after a season of light use. What we find on inspection is often a clay-tile liner with cracked joints from decades of settling and thermal stress, or a mortar crown that has eroded from years of exposure. Because many of these fireplaces were built for decorative or occasional use, the original construction wasn’t always up to the demands of even moderate burning. We repair what we find, in-house, so there’s no handoff to a third party. Our Chimney Repair scope covers liner work, masonry, caps, and dampers.
Chimney Cap Installation
Signs you need it
You find bird nests, leaves, or rainwater inside the firebox, or you hear animals in the chimney.
What it costs in Florence-Graham
A new chimney cap installation typically runs $230 to $480 in Florence-Graham depending on the flue size and cap material.
How we do it
We measure the flue opening, select a stainless or copper cap sized to the tile, and secure it to the crown with mechanical fasteners so animals and rain stay out while draft is maintained.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, missing mesh panels, or has blown off in wind.
What it costs in Florence-Graham
Replacing a deteriorated chimney cap in Florence-Graham typically costs $250 to $500, which includes removing the old cap and fitting the new one.
How we do it
We take off the damaged cap, inspect the crown beneath for water damage, then install a replacement cap matched to the flue dimensions and the home’s exposure.
Chimney Liner Installation
Signs you need it
A camera inspection reveals cracked clay tile joints, or you see flue tile pieces in the firebox, or there’s visible smoke staining on the chimney chase.
What it costs in Florence-Graham
Chimney liner installation in Florence-Graham generally runs $2,600 to $5,800 depending on the liner material, chimney height, and whether the old tile needs removal.
How we do it
We size the flue, pull a DuraFlex stainless flexible liner through the existing chase when conditions allow, and connect it to the appliance or fireplace with a properly sealed top plate and cap.
Chimney Flashing Repair
Signs you need it
You see water stains on the ceiling near the chimney chase, or the flashing is visibly lifted, rusted, or missing sections.
What it costs in Florence-Graham
Chimney flashing repair in Florence-Graham typically runs $350 to $800, with the cost driven by how much of the flashing is accessible and the roofing material around the chimney.
How we do it
We remove the failing flashing, cut and fit new step and counter-flashing, and seal all transitions with a high-temperature roofing sealant to prevent water intrusion.
Chimney Crown Repair
Signs you need it
The mortar crown on top of the chimney is cracked, spalling, or has sections missing, letting water into the masonry below.
What it costs in Florence-Graham
Chimney crown repair in Florence-Graham typically costs $400 to $1,000 depending on the crown size and whether a full recast is needed.
How we do it
We clean the existing crown, repair cracks with a proper crown-coat material, or recast the crown with a reinforced mortar mix that slopes water away from the flue.
What Chimney Repair Costs in Florence-Graham
| Item | Typical range in Florence-Graham |
|---|---|
| Chimney cap installation | $230 – $480 |
| Chimney cap replacement | $250 – $500 |
| Chimney liner installation | $2,600 – $5,800 |
| Chimney flashing repair | $350 – $800 |
| Chimney crown repair | $400 – $1,000 |
Should I reline my original clay-tile chimney or can it be repaired?
It depends on the condition of the tile. Hairline cracks and deteriorated mortar joints can often be restored with HeatShield resurfacing without a full liner replacement, but if the tile itself is broken or missing sections, a DuraFlex stainless liner is the correct fix. We’ll show you the camera footage before recommending either path.
Does a cracked flue in a fireplace we barely use actually need repair?
Yes. Even occasional use pushes heat and combustion gases through the cracks, and a cracked flue can allow those gases into the wall cavity. In Florence-Graham’s tightly packed homes, that’s a shared fire risk. If the fireplace will ever be used again, the flue needs to be sound. Call (855) 382-6159 and we’ll inspect it.
Brands We Service in Florence-Graham
We install and service materials from six professional-grade brands, including DuraFlex flexible liner systems, HeatShield resurfacing, Gelco caps and dampers, and Olympia Chimney components. These are contractor-supply lines, not big-box substitutes. For specifics on what we stock and why it matters, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Florence-Graham, CA
| Service | Typical range in Florence-Graham |
|---|---|
| Chimney sweep (inspection + cleaning) | $200 – $350 |
| Chimney cap installation | $230 – $480 |
| Chimney cap replacement | $250 – $500 |
| Chimney liner installation | $2,600 – $5,800 |
| Chimney flashing repair | $350 – $800 |
| Chimney crown repair | $450 – $950 |
| HeatShield resurfacing | $1,800 – $3,200 |
| Dryer vent cleaning | $150 – $300 |
Prices in Florence-Graham push higher when the chimney is hard to access, like a two-story chase on a narrow lot with poor ladder or scaffold setup, or when the original flue tile has to be broken out rather than relined over. We give you an upfront price before any work starts, so there’s no surprise when the invoice comes.
Neighborhoods We Serve in Florence-Graham
Florence-Graham is a compact unincorporated community, and we work throughout the 90001 ZIP code. Our technicians are familiar with the housing patterns here that affect chimney work.
- Central Florence-Graham
- Graham Avenue corridor
- Miramonte Boulevard area
- Nadeau Street area
- Near the Florence Avenue commercial strip
Most calls in Florence-Graham can be scheduled within the same week, and we route multiple jobs per day through the surrounding unincorporated communities.
Service Area – Cities Near Florence-Graham
We also serve the communities around Florence-Graham, including Huntington Park, CA, Walnut Park, CA, Willowbrook, CA, and South Gate, CA. If you’re in one of those cities and need a chimney inspection or repair, call (855) 382-6159 and we’ll get you on the schedule.
Serving Florence-Graham, CA — Our Local Coverage Area
We’re based in the Florence-Graham area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Florence-Graham
Most Florence-Graham calls are scheduled within the same week. Because we route multiple jobs per day through the unincorporated corridor and neighboring cities, we can often offer a next-day slot if the situation is urgent. Call (855) 382-6159 and we’ll find the earliest open time.
Most chimney repair work, including liner installation and cap replacement, does not require a separate county permit. If your project does require one, we’ll tell you before we start and we handle the coordination on our end. Florence-Graham is unincorporated, so county rules apply rather than city rules.
Yes. Many Florence-Graham homes have converted their original wood-burning fireplaces to gas logs or inserts, and the flue still needs inspection and cleaning just like a wood flue. We service gas fireplace venting, furnace flues, and water heater flues throughout the 90001 ZIP code.
If your chimney hasn’t been looked at in years, get it inspected before you use it again. We serve Florence-Graham with the full scope: sweep, repair, and dryer vent fire prevention, all from one provider. Call (855) 382-6159 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Florence-Graham Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Veronica Flores"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Jodi Brooks"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Marcy Padgett