Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Florence-Graham
Dryer vent cleaning in Florence-Graham typically costs $89 – $180 for a standard single-family bungalow and takes about 45 – 75 minutes from setup to final airflow test. We work throughout the 90001 ZIP code weekly, often same-week for booked appointments. If your dryer is taking two cycles to dry a load or the laundry room feels humid after a cycle, call us at (855) 382-6159 and we’ll get it sorted.
Florence-Graham’s housing stock creates a specific set of dryer vent problems you won’t find in newer developments. Most homes here were built between the 1920s and 1960s, and many laundry areas were retrofitted into back porches, closets, or converted utility nooks long after original construction. That means vent runs are rarely straight. They snake through walls, jog around framing, and often terminate in narrow side yards that sit just a few feet from the neighbor’s wall. We know exactly what that looks like, because we see it here every week.
Why Corona Chimney Sweep Is Florence-Graham’s Preferred Dryer Vent Cleaning Company
Florence-Graham is a dense, unincorporated Los Angeles County community where the homes sit shoulder-to-shoulder on small lots. That physical reality changes dryer vent cleaning from a routine chore into a shared-safety issue. A clogged vent in a home with a five-foot side-yard setback doesn’t just threaten that house. It threatens the stucco bungalow next door, and the duplex behind it. Our technicians understand that layout because they work inside it constantly.
We’re a full-service venting company, not a single-service cleaning crew. The same technicians who sweep chimneys and repair flue liners also clean dryer vents. That matters more than most homeowners realize. A dryer vent is a combustion-venting system under lighter load, and the airflow dynamics, termination requirements, and clearance standards are similar. When our techs inspect a dryer vent in Florence-Graham, they’re looking at it with the same eye they’d give a chimney flue. That’s how blocked vents get caught before they become fires.
Nolan Ferris, our owner, built the company around one principle: we repair what we find. If a dryer vent cleaning in Florence-Graham uncovers a crushed transition duct, a missing termination hood, or a vent run that was never installed to code, we don’t hand you a phone number for someone else. We fix it on the spot with the right materials. For dryer vent transitions and terminations, that means solid metal connectors and proper 4-inch vent hoods with backdraft dampers, not whatever vinyl flex is on the shelf at the hardware store.
Read more about our full Dryer Vent Cleaning scope before you book. If you’re looking for service in this specific area, we have a full overview of Dryer Vent Cleaning in Florence-Graham that covers what local homeowners can expect.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Florence-Graham
Dryer Vent Cleaning
This is the core service: clearing lint, debris, and obstructions from the full length of the dryer vent run, from the dryer connection through the termination point on the exterior wall. In Florence-Graham, we routinely find vents that have never been cleaned since the dryer was installed. That’s not an exaggeration. The mild climate and infrequent use of some laundry setups means lint packs into the vent and sits there for years. We use rotary brush systems sized for 4-inch residential vents, and we run an airflow test before and after to document the improvement.
Expect the cleaning itself to take 45 – 75 minutes for a standard run in a 90001 bungalow. If the vent terminates in a tight side yard, we work from both ends to clear it. No shortcuts. The lint comes out, the vent gets inspected, and the airflow gets verified.
Dryer Vent Inspection
In homes built before the 1960s, a dryer vent inspection should never be skipped. Florence-Graham’s original bungalows predate modern dryer venting standards. Many have vent runs that were improvised years ago: corrugated foil stuffed behind a dryer, a flexible duct pinched between the appliance and the wall, or a run that spans fifteen feet with four elbows. Those are fire hazards. Our inspection checks the entire run for sags, holes, separation at joints, and termination issues. We give you a straight answer about what needs fixing and what can wait.
Dryer Vent Repair and Replacement
If we find a crushed transition duct, a disconnected run, or a termination hood that’s rusted or missing its damper, we repair it. We stock solid metal transition ducts and 4-inch vent termination hoods in our service vehicles for this exact reason. Florence-Graham homes frequently need longer or custom-fitted transitions because the dryer sits in a converted porch or closet where the vent connection is awkward. We cut and fit on site.
Multi-Family Dryer Vent Cleaning
Florence-Graham has a substantial stock of duplexes, triplexes, and small apartment buildings. Lint buildup in shared vent stacks or common laundry areas is a building-wide liability. We clean individual units and common vent infrastructure for landlords and property managers. Written documentation after each service keeps the building owner’s maintenance records defensible. If you own or manage a multi-family property in 90001, ask about scheduling multiple units on the same visit.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Florence-Graham
We work with professional-grade venting and dryer exhaust products, not big-box substitutes. When a Florence-Graham home needs a new dryer vent transition or termination, we install components from manufacturers like DuraFlex. Their metal transition ducts hold their shape behind a dryer, unlike the crushable foil tubing that fails so often in tight laundry closets. We also use Olympia Chimney termination hoods and components where the install calls for a louvered or dampered exhaust exit. On a recent job in the 90001 ZIP code, our tech found a 1950s stucco bungalow where the dryer vent hose had disconnected behind the unit, blowing lint into the wall cavity for years. We reconnected it with a new DuraFlex transition duct and installed a proper 4-inch metal vent hood with a backdraft damper on the exterior wall, restoring safe airflow and preventing future lint buildup.
See the difference
Before
After
Before
After
Before
AfterCommon Dryer Vent Cleaning Problems We See in Florence-Graham Homes
- Crushed corrugated transition ducts. In older bungalows where the dryer sits in a converted porch or closet, the space behind the appliance is tight. Foil or vinyl transition ducts get crushed against the wall, restricting airflow and trapping lint. Dryers run longer, clothes stay damp, and the motor works overtime.
- Vent terminations blocked by vegetation. Florence-Graham’s small side yards often have mature shrubs, stored items, or accumulated debris right where the vent exits. A blocked termination pushes lint back into the duct and eventually into the dryer itself.
- Long vent runs with multiple elbows. Retrofitted laundry areas in older homes frequently have vent runs that bend two, three, or four times before reaching the outside. Every elbow reduces airflow and adds a lint trap point. These runs need cleaning more often than straight shots.
- Damaged or missing termination hoods. The exterior vent hood takes the brunt of weather, yard work, and sometimes pest activity. Rusted louvers, stuck dampers, and missing screens are common. Without a functioning termination, the vent becomes an open hole for rodents and debris.
In Florence-Graham’s tightly packed bungalows, dryer vents often terminate into narrow side-yard setbacks shared with neighboring walls. Lint can accumulate in crawlspaces or wall cavities rather than venting freely, creating a fire risk that is magnified by the proximity of adjacent homes. This isn’t a theoretical concern. When homes sit five to seven feet apart, a lint-fed dryer fire in one structure has a direct path to the next. That’s the reality of the building density here, and it’s why we treat every cleaning as a fire-prevention measure, not a convenience call.
Pricing for Dryer Vent Cleaning in Florence-Graham, CA
A standard dryer vent cleaning for a single-family home in Florence-Graham runs $89 – $180. That covers the full-length cleaning, airflow verification, and a basic inspection of accessible vent sections. If you have a long vent run over 15 feet, multiple elbows, or a roof termination that requires ladder access, expect the price to move toward the upper end or slightly above.
Repairs are quoted separately and only after we show you what we found. We don’t do blind recommendations. If your vent needs a new transition duct, a replacement termination hood, or a section of rigid duct replaced, you’ll see the issue and get a price before we do anything. Estimates are free, and there’s no pressure to proceed. Call (855) 382-6159 and tell us the address and what’s going on with your dryer. We’ll give you a real number.
We Also Serve Cities Near Florence-Graham
Our service area covers the unincorporated Florence-Graham community and the surrounding cities. We regularly schedule jobs in Huntington Park, Walnut Park, Willowbrook, and South Gate. If you’re in one of these adjacent areas, the same crew and the same pricing structure apply. No dispatch fee games just because you’re on the other side of Alameda Street.
Serving Florence-Graham, CA — Our Local Coverage Area
We’re based in the Florence-Graham area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Florence-Graham
Once a year for most homes in Florence-Graham, assuming normal use. If you have a large household doing multiple loads a day, have a long vent run with multiple elbows, or your dryer is in a converted space with tight clearances, clean it every six to nine months. The density and age of the housing stock here doesn’t make lint build faster, but it makes the consequences of ignoring it worse. A blocked vent in a home with a shared side-yard wall doesn’t just threaten that home. Annual cleaning is the simplest fire-prevention step you can take. Call (855) 382-6159 to schedule.
Clothes taking two cycles to dry, a laundry room that feels hot and humid while the dryer runs, a burning smell, lint accumulating around the dryer door or on top of the machine, and the exterior vent hood not opening when the dryer is on. Any one of these is enough to book a cleaning. In Florence-Graham’s older bungalows, we also see homeowners who notice the dryer vibrating more than it used to because the vent restriction is making the motor work harder. That’s a warning sign too.
Yes. Tight side-yard access is the standard condition in Florence-Graham, not an exception. We carry equipment sized for narrow access and work from both ends of the vent run. If the termination is blocked by vegetation or stored items, let us know when you book and we’ll plan for clearing access. We’ll need room to reach the termination with the rotary brush, but the opening only needs to be about as wide as a person’s shoulders. Most Florence-Graham side yards are workable without major clearing.
No. Plastic, vinyl, and foil transition ducts are fire hazards and should be replaced with solid metal. They crush easily, trap lint aggressively, and can melt or ignite if lint inside the duct ignites. In Florence-Graham’s older homes, we find vinyl and foil ducts routinely, often installed decades ago when building codes were looser. We replace them with rigid or semi-rigid metal transition ducts during cleaning visits. If you have a plastic vent duct, replace it now. The cost of the part is minimal. The cost of ignoring it is not.
Yes. We clean dryer vents in duplexes, triplexes, and small apartment buildings throughout Florence-Graham and the 90001 ZIP code. Lint buildup in shared vent stacks is a building-wide issue, and landlords have a responsibility to maintain safe venting for tenants. We can schedule multiple units on the same visit and provide written documentation after each service. If you manage a property, call (855) 382-6159 and ask about a multi-unit dryer vent cleaning quote.
Written by Nolan Ferris, Owner at Corona Chimney Sweep, serving Florence-Graham and Los Angeles County.