Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Brea
Dryer vent cleaning in Brea typically costs $150 – $285 for a standard single-story home with a short vent run, and we can usually get to Brea homes within a few days of your call. Lint buildup is the leading cause of dryer fires in the U.S., and Brea’s older tract homes often have vent runs that were never cleaned since the house was built. If your dryer takes two cycles to dry a load, or the laundry room feels humid after a cycle, call Corona Chimney Sweep at (855) 382-6159. We’re the same team that handles chimney sweeping, chimney repair, and dryer vent cleaning throughout North Orange County, so we see the connection between clogged vents and aging chimney flues that most vent-only companies miss.
The mild, dry Brea climate means dryers get used heavily year-round, not just in winter. That’s a lot of lint moving through ducts that may be undersized, kinked, or partially crushed. We do more than run a brush through. We scope every vent with a camera, show you what we find, and clear the entire run from the dryer connection to the exterior hood.
Key Takeaways:
- Full dryer vent cleaning with camera inspection runs $150 – $285 in Brea for a standard single-story home
- Longer or multi-story vent runs run $250 – $395 and take about an hour
- We service all Brea ZIP codes: 92821, 92822, 92823
- Every job includes photo and camera documentation before and after
- We never recommend replacement parts without showing you the camera footage that justifies it
Why Corona Chimney Sweep Is Brea’s Preferred Dryer Vent Cleaning Company
Brea homeowners call us because we understand how their 1950s and 1960s tract homes were built, and what that means for venting. Many of these houses have original clay-tile chimney flues, brick or stucco-clad masonry fireplaces, and dryer vents that route through exterior walls or crawl spaces in ways a modern home would never be built. That older construction creates specific failure modes, and we know where to look.
Our team is led by Nolan Ferris, and the same technicians who clean your dryer vent also work on chimney liners and caps. That cross-training matters in Brea more than most places, because the uncapped fireplace flue and the dryer vent often sit on the same exterior wall. We find bird nests in vent hoods that originated in the chimney above. We find disconnected flues behind drywall from decades-old remodels. And when we find a problem in the chimney that affects your dryer venting, we repair what we find. We don’t hand you a referral slip and tell you to call someone else.
Brea homeowners have told us the same thing across dozens of calls: another vent cleaning company came through, ran a brush, wrote an invoice, and never mentioned the nest clogging the exterior hood or the crushed flex duct behind the dryer. We’re slower on purpose. We scope the run first, show you the condition, clean it, and re-scope. You see the difference on camera.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Brea
Dryer Vent Cleaning With Camera Inspection
Every Brea dryer vent job starts with a camera scope of the full run. We’re not guessing at what’s inside. We can see lint compaction, crushed sections, disconnected joints, and bird or rodent debris. For Brea homes built between the 1950s and 1970s, the vent run might include hard-to-see transitions through slab foundations or attic spaces. After cleaning, we re-scope and show you the before-and-after footage. That’s the standard, not an upsell.
Chimney Cap and Animal Nest Removal
In Brea, a clogged dryer vent is frequently not the whole story. The dry, mild climate and older masonry chimneys make perfect nesting sites for birds and squirrels. If your chimney flue has no cap or a damaged cap, animals get in, build nests, and sometimes those nests fall or get blown into the adjacent vent hood or wall cavity. We remove animal nests from chimney flues and smoke chambers, clear the debris from connected vent runs, and install proper caps that keep animals out without restricting the draft.
Level 2 Inspection for Gas-Converted Fireplaces
Many Brea homes off Brea Boulevard, in the tracts around the Brea Mall, and across the older neighborhoods have fireplaces that were converted to gas logs decades ago. The wood firebox got a gas line, but the original clay flue stayed in place, often uncapped and unlined for gas venting. That’s a venting problem, not just a fireplace problem. If you’re scheduling dryer vent cleaning and you have a gas-converted fireplace that hasn’t been inspected in years, our Dryer Vent Cleaning team can perform a Level 2 inspection of the chimney at the same appointment. We’ll look at the clay tile liner condition, the damper setup, and whether the flue is properly sized and terminated for a gas log set.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Brea
We don’t treat dryer vent cleaning as a commodity service. The materials we use and recommend are the same ones professional chimney contractors stock, not big-box substitutes. We work with DuraFlex stainless flexible liner systems when a Brea home needs a new liner or a retrofit around an older clay flue that’s cracked or undersized. HeatShield resurfacing is available for qualifying flues with deteriorated mortar joints or hairline cracking, which saves homeowners from a full liner replacement when the structure is otherwise sound. We also service and install components from Olympia Chimney, including caps and dampers, where a Brea chimney needs proper termination. If your venting problem extends into the chimney, we’re already equipped with the right materials on the truck.
Common Dryer Vent Cleaning Problems We See in Brea Homes
- Bird nests in the vent hood or chimney flue: Brea’s dry climate and mature trees around the older tracts make chimneys and vent hoods attractive nesting sites. We’ve pulled full nests out of uncapped clay flues and from the same wall cavity as the dryer vent.
- Undersized or kinked transition ducts: In 1950s and 1960s tract homes, laundry closets are often tight, and the flex duct between the dryer and wall gets crushed behind the machine. That restriction traps lint faster than any other cause.
- Long horizontal runs through crawl spaces or attics: Some Brea additions and remodels extended dryer vent runs well beyond the 25-foot maximum most dryers can push. Every extra foot and every 90-degree bend reduces airflow and accelerates lint accumulation.
- Disconnected or separated vent joints from old remodels: We’ve found vent sections that pulled apart inside wall cavities during kitchen or laundry room remodels, dumping warm, lint-laden air into the house instead of outside. Camera scoping finds these before they become a fire or mold problem.
See the difference
Before
After
Before
After
Before
AfterPricing for Dryer Vent Cleaning in Brea, CA
A standard dryer vent cleaning in Brea runs $150 – $285 for a single-story home with a short, straight vent run. That price includes the camera scope before and after, cleaning from the dryer connection all the way to the exterior hood, and a photo report you can keep. Two-story homes or runs over 15 feet typically run $250 – $395. If we find a bird nest in the vent hood or chimney flue, nest removal adds $75 – $150 depending on how much debris has accumulated. We don’t quote those numbers to hide the scope. We quote them so you know what to expect before you book. Call (855) 382-6159 for an exact quote on your Brea home. Estimates are free, and we’ll tell you plainly if your vent can safely wait.
We don’t recommend liners, caps, or any repair work without showing you camera evidence first. Nothing gets sold on a hunch. If your vent is clean but the chimney above it is compromised, we’ll show you that footage too and give you a straight answer about what’s urgent and what can wait.
We Also Serve Cities Near Brea
Corona Chimney Sweep provides Dryer Vent Cleaning in Brea and the surrounding North Orange County communities. We regularly route our techs into Placentia, Rowland Heights, Fullerton, and Yorba Linda on the same schedule, which means faster response times for Brea customers. If you’re in any of these nearby cities, we can often combine your appointment with an existing route in the area and get to you sooner.
Serving Brea, CA — Our Local Coverage Area
We’re based in the Brea area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Brea
Because the lint trap only catches a fraction of the lint your dryer produces, and the rest is moving through the vent run behind the wall. In Brea’s older tract homes, that run is often long, kinked, or partially clogged with years of compacted lint. Even with a clean lint screen, a restricted vent makes dryers work harder and longer. Call (855) 382-6159 and we’ll scope the run to show you exactly where the restriction is.
Yes, and here’s why: many Brea fireplaces were converted to gas logs without addressing the original clay flue, damper, or cap. That flue is still there, often uncapped, and often shared structurally with the same wall where your dryer vents out. A Level 2 inspection at the same time as your dryer vent cleaning catches animal nests, cracked tile liners, or disconnected flues that can affect the whole venting system. We don’t upsell the inspection. We show you what the camera sees and let you decide.
You usually can’t, which is why camera inspection matters. Lint can compact inside the vent run, at a bend, or against the exterior hood’s flapper without ever blowing out onto the ground. The most common warning signs are clothes taking longer to dry, a burning smell while the dryer runs, a laundry room that feels humid, or an exterior vent flapper that doesn’t open fully. If any of those sound familiar, call us for an inspection before running the dryer again.
Bird nests. Brea’s older neighborhoods have mature trees, uncapped chimney flues, and vent hoods that haven’t been replaced in decades. We regularly pull nests out of vent hoods and flues before we’ve even started cleaning the vent run itself. After we remove the nest, we’ll show you the damage on camera and recommend a cap that keeps it from happening again.
Yes, in nearly every case. An original clay flue with no cap is an open invitation for birds, squirrels, rain, and Santa Ana wind-blown debris. Caps cost less than a single nest removal and they keep your entire venting system cleaner. We install caps sized for your flue, and if the flue itself is cracked or spalling from decades of exposure, we’ll show you that footage and talk through options, including DuraFlex relining or HeatShield resurfacing where the conditions qualify.
Call Corona Chimney Sweep for Dryer Vent Cleaning in Brea
If your Brea dryer is taking too long, running hot, or you haven’t had the vent cleaned since you moved in, call (855) 382-6159. We’ll schedule a camera-scoped cleaning, show you exactly what’s in the vent, and leave you with documentation of the work. If we find a problem in your chimney, we fix it ourselves. One provider, every venting hazard.
Written by Nolan Ferris, Owner at Corona Chimney Sweep, serving Brea and North Orange County since day one.